Kval 965X, Руководство по обслуживанию, Страница: 48 / 96

Grease Locations for the 965X
3-18
965X Service Manual
Grease Locations for the 965X
Locations of Cutter Head Bearings
For lubrication schedule information, see “Lubrication Schedule” on page 3-12. Figure 3- 12
shows the X,Y, and Z axis bearings of the
Cutter Head
from the back section viewpoint. The bear
-
ings are color coded for easy identification. (X-yellow, Y-blue, and Z- red).
1.
Park the Cutter Head, see “How to Prepare the 965X for Greasing” on page 3-17.
2.
Perform Lockout/Tagout.
3.
Identify zerk fittings and apply EP-2 grease.
4.
After lubrication is completed, reverse Lockout/Tagout .
FIGURE 3- 12.
Cutter Head Bearing Locations
This machine is a powerful electro-mechanical
motion control system. If servicing this machine, fol
-
low the safety guidelines. Failure to do so can result in
damage to equipment and/or serious injury to person
-
nel.
Shutdown the machine and follow the
“Lock Out
Tag Out procedures
Caution
Z Axis Bearings:
Four Bearings move the Cutter
Head vertically up and down.
Y Axis Bearings:
Four Bearings move the Cut
-
ter Head front and back.
Located on the top of the
plate,
X Axis Bearings:
Four Bearings move the Cutter
Head across the machine. Located
on the bottom of the plate.