LUBRICATION REQUIREMENTS
Linear Bearings
If bearing is equipped with a grease fitting, it should receive 1
Gram (one pump from grease gun) of Dura-Lith Grease (KVAL
P/N Lube EP-2) grease every 30 days. Bearings without grease
fittings have been pre-lubricated at the factory and do not require
further lubrication.
Flange Bearing
Dura –Lith grease; 1 gram every 60 days.
Lubricate special high speed bearings
With optimal long time PD2 (KVAL P/N
Lube
PD2) bearings must be re-lubricated once every 60 days.
Approved Lubrication Products
Chevron AW Hydraulic Oil 32 – or KVAL P/N SYSLUBG or G-C lubricants light
AW R&O or Mobile DTE 24 or Shell Tellus32 or Gulf Harmony 32.
Lubricator Adjustments
Using knob on the top of the lubricator, adjust until one drop per every other cycle is
used (as observed through sight glass.) Turn flow all the way open then reduce flow
to proper specifications.
Gear Motor Lubrication Requirements
Oil change is recommended after 2000 hours or six months of operation. Use AGMA
#8 gear lube or MOBILUBE HD 80 W-90 or equivalent.
