Motor is stuck or has
stopped
Juice yield is low
Juicing bowl shakes in the
middle of operation
Seems like juicing screw is
grinding
Juicer is noisy
ㆍ
Check that the cord is plugged in properly
ㆍ
Check all parts are assembled correctly.
ㆍ
The juicer may stop if the ingredients are fed into the hopper too quickly.
ㆍ
Turn the switch to
OFF
position and press down
REVERSE
switch to push up the
ingredients. Press the
FORWARD
switch to pull the ingredients down. (repeat
if needed)
ㆍ
Turn the switch to
OFF
position and unplug the power cord from the wall outlet.
Let the juicer rest to cool off from overheating.
ㆍ
When using the ingredients with hard seeds, pit before extraction. Seeds may
damage the strainer if not pitted from the ingredients.
ㆍ
Every ingredient yields diff erent amounts of juice.
ㆍ
Soak the ingredients in water before extracting if the ingredients are dry or
not fresh.
ㆍ
When extracting ingredients like carrots or beets, extract with a combination of
other fruits and vegetables with more water content to increase the juice yield.
Cut ingredients to 4-5 inches long and 1 in wide for optimal extraction.
ㆍ
Check that the compression silicone is assembled properly in the unit.
ㆍ
When extracting seeded fruits like tomatoes, the strainer may get clogged with
the excessive amount of small seeds. Pour water through the hopper to unclog
before continuing extraction.
ㆍ
It is normal for the juicing bowl to shake a little bit during operation.
ㆍ
The juicing screw and the strainer are closely aligned with small tolerances.
Do not operate without inputting any ingredients for more than 30 seconds.
ㆍ
The rotation wiper may make a squeaking noise while wiping the juicing bowl.
After inserting ingredients the noise should disappear.
ㆍ
Turn the switch to
OFF
position and unplug the power cord from the wall outlet.
Check the parts are assembled properly.
ㆍ
Check that the juicer is on a level surface.
ㆍ
Check that the ingredients are cut to appropriate size.
*The warranty and product liability do not cover problems related to commercial or improper use of the product.
Problem
Possible Reasons & Solution
I see a separation in the
juice extracted
The juice leaks out of the
top set
I see discoloration of the
plastic parts
ㆍ
There may be a separation in the juice due to the ingredients' density after
extraction. This is diff erent from oxidation that is caused by juicing with
a traditional high speed juicer.
ㆍ
The juice may leak if the compression silicone is not assembled properly.
Disassemble and ensure the compression silicone is assembled properly. (pg 15)
ㆍ
After use, clean the juicer immediately to prevent discoloration.
ㆍ
Beta carotene (found in carrots and spinach) pigment may discolor the plastic
parts of the juicer. Rub the parts with a little bit of cooking oil then clean with
a mild soup.
ㆍ
The silicone parts can be removed and cleaned separately.
Problem
Possible Reasons & Solution
‘LIFE TASTES GOOD’
GLOBAL COMPANY
Troubleshooting
17
16