`
Page 4
•
Do not move the appliance when in use. Allow the grill to cool to less than 115
o
F[46
o
C] before moving or
storing.
•
Do not use the appliance if damaged in any manner or has leaks, call
Ocean Solutions Interna61
(0)7 3807 6033
•
Any modification to this appliance may be dangerous and should not be performed.
•
Do not operate grill on a combustible construction.
•
NEVER leave cooking food unattended. Open lid frequently and cook with lid open as much as possible
when cooking at higher temperatures.
•
Carbon monoxide (CO) is an odorless, clear gas that can cause flu-like symptoms, sickness, illness and
possibly death if produced inside an enclosed area without proper ventilation. NEVER use indoors.
o
Profile 1400 only. Never cook with the lid closed.
B – UNPACKING & INSTALLATION:
Unpack your grill taking care to remove all packaging materials. The grill is completely assembled, no
assembly required. Inspect the grill for damage prior to use. If damage is found, do not attempt to operate
your grill. Contact
Ocean Solutions Interna61 (0)7 3807 6033
or e-mail at
C – GRILL INSTALLATION:
This appliance must be securely mounted when used on a boat or
placed on a sturdy, level, non-
combustible surface when used on shore
. Kuuma offers a full line of mounting kits and hardware (sold
The mounting location must be outdoors in an area free of overhead combustible materials and provide a
minimum clearance of 60cm from the sides and back, and 1.5m below any combustible materials.
This appliance is not intended to be installed in or on recreational vehicles.
Installation must conform to AU/NZS 5601. Units are not designed to be permanently connected to gas
cylinders or gas supply. Gas supply must be disconnected upon storage. Gas must not be connected to the
device while travelling.
D – GAS SUPPLY:
D-1 INSTALLING THE GAS CONTROL:
• Position the control valve or regulator as shown in FIG. 1a & 1b, aligning the notch on the orifice fitting with the
dimple on the burner tube.
• Gently insert the orifice fitting into the burner tube until dimple aligns with groove on orifice fitting.
• Rotate180 degrees
• Pull back slightly on gas control to check that it is locked in place.