Kustom PA112-S, Руководство пользователя

Страница: 5 / 8

2. IN
This ¼ inch jack is used to connect the PA112-S to a line level output such as the subwoofer out on a
PA100T. It has a built in crossover to allow connection to full range line level outputs. NOTE: Do not
connect the speaker outputs on a power amp to this jack!
2. IN
3. OUT
1. VOLUME
4. POWER
5. AC POWER CORD RECEPTACLE
3. OUT
This ¼ inch jack parallel’s the signal on the IN jack. The purpose of this jack is to pass the signal
going to the IN jack to another Line level device such as a second powered PA or Subwoofer. NOTE:
This is not a power amp output. It will not drive an unpowered (passive) speaker.
1. VOLUME
Controls the volume of the subwoofer. Adjust to get the best mix between your midrange speakers
and PA112-S. It is common for this control to be set between ½ and full when using with a PA100T
system.
4. POWER
This switch activates AC power to the powered PA.
5.AC Power Cord Receptacle
Insert the PA112-S’s AC cord firmly into the AC receptacle. Be sure to use the cable provided with
your PA112-S. The power cord can be removed for storage or replacement if damaged. Note: Replace
the AC cord if its protective jacket is damaged or ground pin is damaged or removed.