TM
Visit: www.evpeurope.com
Call: +44 (0) 1926 419441
E-mail: [email protected]
EVP Ltd, Unit 4, Benford Court, Lower Cape, Warwick, CV34 5DA
Company Registration Number: 9121263
VAT number: 196484653
AUTO CHARGE 12, 091-165-12
INSTALLA TION GUIDE & MANUAL
Notes:
INSTALLATION WIRING DIAGRAM
1. 115VAC Input Power and Charger Output Power strain
relief cover not shown for clarity. Refer to “Important Safety
Instructions” section of this manual.
2. Charger output power connections, AWG 14, for 20 feet
Maximum. Consult factory if longer length is required.
SPECIFICATION & OUTLINE
Input: 115/120VAC, 50/60 Hz, 2.5 Amps
Input Fuse: 5 Amps,
CAUTION: DISCONNECT SUPPLY BEFORE CHANGING FUSE
Output: 13.25 VDC
Output Fuse (Optional): 25 Amps
Output Current: 12 Amps
Charge Indicator: 0-15 amps 5%
Weight: 10 lbs
Regulatory Approvals
Recognized Component, Battery Chargers, Automotive Type
(BBGQ2) File E225909
1. UL1236 Standard for Battery Chargers
2. Canadian Standards Association, Standard for Battery
Chargers, C22.2 No. 107.2
3. Federal Specification for Emergency Medical Care Vehicles,
KKK-A-1822E
INDICATOR INSTALLATION
1. Locate Indicator in a convenient place on the vehicle.
2. Place the template in position and center punch in 4
places.
3. Drill holes as shown.
4. Cut out square hole.
5. Connect wiring to charge in accordance with the
instruction in the charger installation instructions.
6. Install as shown.
7. Insert (4) #8-32 screws supplied and tighten. (Caution: do
not over tighten because you will bend the plastic bezel
and break the watertight seal).
WARRANTY
All products of Kussmaul Electronics Company Inc. are
warranted to be free of defects of material or workmanship.
Liability is limited to repairing or replacing at our factory,
without charge, any material or defects which become apparent
in normal use within 3 years from the date the equipment was
shipped. Equipment is to be returned, shipping charges prepaid
and will be returned, after repair, shipping charges paid.
Kussmaul Electronics Company, Inc. shall have no liability
for damages of any kind to associated equipment arising
from the installation and /or use of the Kussmaul Electronics
Company, Inc. products. The purchaser, by the acceptance of
the equipment, assumes all liability for any damages which may
result from its installation, use or misuse, by the purchaser, his
or its employees or others.
9
SPECIFICATIONS:
Input:
115/120VAC, 50/60 Hz, 2.5 Amps
Input Fuse:
5 Amps,
CAUTION: DISCONNECT SUPPLY BEFORE CHANGING FUSE
Output:
13.25 VDC
Output Fuse (Optional):
2
5
Amps
Output Current:
12 Amps
Charge Indicator:
0-15 amps 5%
Weight:
10 lbs
SPECIFICATION & OUTLINE
11.375
10.375
4.375
4.375
5.50
9/32" DIA.
OUTLINE DRAWING
Regulatory Approvals
Recognized Component, Battery Chargers, Automotive Type (BBGQ2)
File E225909
1. UL1236 Standard for Battery Chargers
2. Canadian Standards Association, Standard for Battery Chargers, C22.2 No. 107.2
3. Federal Specification for Emergency Medical Care Vehicles, KKK-A-1822E
