Maintenance
Final Assembly
• Pedestal Stand Assembly
2. Insert locking pin through bottom of pivot tube.
Figure 2. Tip mixer up, Pivot Mount Plate freely rotates down
Rotate pivot mount plate away from drum and onto frame stop. Back
off thumbscrew to allow clearance for inserting pivot tube on stand
through tube. (Figure 3)
Figure 6. Unit ready for mixing
4. Once the stand has been attached, move to the opening side of
the drum and begin tilting the mixer upright onto the stand.
Always bend your knees and use correct posture for lifting.
Always tilt from the front of the mixer. (Figure 5)
Figure 7 – Rotate Pivot Mount Plate to wheelbarrow
stowed position
Converting unit back to
Wheelbarrow from Stand
3. Insert pivot tube of pedestal stand assembly
through pivot mount and tighten thumbscrew.
(Figure 4)
1. Place two halves of the support legs
together and insert pivot tube through the
center of the legs to join together. (Figure 1)
5. Once mixer has been tilted upright onto the
stand, the mixer should be tipped back into mix-
ing position before operating. (Figure 6)
To convert unit back to wheelbarrow operation follow the direc-
tions for assembling and attaching the pedestal stand to the unit
in reverse. Make sure to tighten thumbscrew and rotate the pivot
mount plate about the axle to its wheelbarrow stowed position
before using the unit in its wheelbarrow function. (Figure 7)
Figure 5. Tilt mixer upright onto
stand
9
-Tip mixer, as if dumping contents, and place
squarely on opening of drum. The pivot mount
plate will rotate freely about the wheel axle from
its wheelbarrow stowed position. (Figure 2)
Figure 3. Rotate Pivot Mount Plate onto Frame
Stop
