The KSL
This setting must be carried out on a horizontal
surface. The track of the rear wheels is correct if the
distance between the rear wheels is the same at the
front and the back (x=y) – measured at the height
of the centre of the axle.
1.
Loosen the bolts
A
on both clamp sets.
2.
Rotate the axle tube
B
to adjust the correct position
of both rear wheels.
3.
Retighten the bolts on both sides.
A
= 9 Nm
6.7.2 Adjusting the Removable Axle
Open-end spanner (19) / Straddle spanner (11)
■■□
1.
Remove the rear wheel.
2.
Hold the end of the removable axle
B
using the straddle
spanner.
3.
Adjust the length L of the removable axle by turning the
nut
A
. The length is correctly adjusted if the removable
axle engages correctly when installing the wheel and
the wheel has just minimal clearance.
The wheels must be exchanged (left to right side
and vice versa) after adjusting both removable axles.
The adjustment must now be checked or carried out
again to ensure the wheels can be switched.
6.7.3 Replacing an axle
A new axle must be used to change the wheel camber.
Allen key (5 mm)
■■□
1.
Remove both rear wheels.
2.
Remove the screws
A
, the lower parts of the axle
holders
B
and the axle
C
.
3.
Replace the axle with a new one with the desired wheel
camber.
4.
Reinstall the lower parts of the axle holders using screws
A
but only tighten slightly.
5.
Ensure that the rear wheels are parallel, see
Ensuring the rear wheels are parallel, page 23
.
6.
Tighten screws on both sides.
A
= 7 Nm
6.7.4 Repairing or changing an inner tube
Tyre lever
■■□
24
1659346-A
Содержание KSL
Страница 30: ...Notes ...
Страница 31: ...Notes ...
