8. Preparation for Measurement.
8.1
Before testing Always Check the Following.
At Power “ON”, read the display to make sure the
“ R e p l a c e B a t t e r y ” m e s s a g e d o n o t a p p e a r s .
There is no visual damage to the instrument or Test leads.
Test lead Continuity with a continuity meter.
9. Battery Replacement
Your Digital RCCB / ELCB Tester’s battery is situatedc under the
tester.
Your Smart-test display will indicate you when the battery need to
be replaced.
Disconnect the Test leads from the instrument, remove the battery
cover and the batteries.
Replace with eight 1.5V R6 or L6 batteries, taking care to observe
correct polarity.
Replace battery Holder and the Battery cover.
10. Fuse Replacement
The Fuse is located under the Battery Holder. To replace the
Fuse, proceed as per Battery replacement procedure to open
the battery cover, then remove and replace the fuse located
under the Battery holder.
Only replace with the same specification fuse. (2A Fast Blow)
11. Servicing and Calibration
Your Digital RCCB. ELCB tester has been factory Calibrated.
However, it is of good practice to have your instrument
“CERTIFIED” by a National Calibration Facility.
12. Safety Notes
Rated environmental conditions :
1. Indoor use.
2. Installation Category III
3. Pollution Degree 2.
4. Altitude upto 2000 Meter.
5. Relative Humidity 80% Max.
6. Ambient Temperature -5°C ~ 45°C
Observe the International Electrical Symbols listed below.
Meter is protected throughout by double insulation or
reinforced insulation.
Warning ! Risk of electric shock.
!!
Caution ! Refer to this manual before using the meter.
13. Cleaning and Storage :
WARNING
To avoid electrical shock or damage to the meter, do not get
water inside the case.
Periodically wipe the case with a damp cloth and detergent; do not
use abrasives or solvents.
If the meter is not to be used for periods of longer than 60 days,
remove the batteries and store them separately.
8
9
