18
GB
Clean the melting water outlet with the supplied pipe
scraper that can be seen in the figure. The pipe
scraper has to be stored in the outlet.
Occasionally check the defrost water outlet not to be
clogged up.
The most typical case of clogging up in the defrost
water outlet when you put food wrapped in some
paper into the appliance and this paper contacts
back plate of cooling compartment and freezes to it.
If you remove the food right at this moment the paper
will tear and it can cause clogging up in the outlet by
getting into it. So you are asked to be careful -
because of the above - when placing foods wrapped
in paper into the appliance.
In case of increased demand e.g. during heat-
waves, the refrigerator temporarily happens to
operate constantly - during this the automatic
defrosting is ineffective.
Remaining small ice and frost stains on back plate of
the cooling compartment after defrosting period is
not abnormal.
Regular cleaning
It is recommended to wash the inside of the refriger-
ator in 3-4 weeks time.
Household cleaner or soap must not be used.
After you made it no-current wash the appliance
using lukewarm water and wipe it.
Clean the magnet door rubber profile with clean
water.
After cleaning plug the appliance to the mains sock-
et.
Dust and dirt collected on the back of the refrigera-
tor, condenser is recommended to be removed and
clean the evaporative tray on top of the compressor
once or twice a year.
When the refrigerator is not in use
In case the appliance will not be used for a long time
follow these steps:
Break the circuit of the appliance.
Remove foods from the refrigerator.
Defrost and clean it as written before.
Leave the door open to avoid a build up of air inside.
How to change the bulb
1. Break the circuit of the appliance.
2. Unscrew the lamp cover securing screw.
3. Unhook the moving part by pressing it as shown in
the figure.
4. Replace the bulb with one of the same power (the
maximum power is shown on the light bulb cover)
5. Fix the lamp cover in place.
6. Screw the lamp cover securing screw.
7. Reconnect the appliance.
8. Open the door and check if the light comes on.