12
Fig. 4
Open the door and
push the
appliance against
the side of the
kitchen furniture
opposite to that of
the appliance
hinges.
Fasten the
appliance with 4
screws provided in the kit included with the
appliance.
Snap vent grill (C) and hinge cover (D) into position.
Fig. 5
Press in the joint
covers between
the appliance and
the kitchen unit.
Fig. 6
Apply covers (B)
on joint cover lugs
and into hinge
holes.
Fig. 7
Position the
runners (H) inside
the kitchen unit
door as shown in
Fig. 8 and mark
the position of
the external
holes.
After preparing
the holes, screw
the runners to the kitchen unit door using 3.5x16
mm screws.
D727
C
D
D724
D726
B
D094
20mm
H
Fig. 8
Open both the
appliance door
and that of the
kitchen unit to
approx. 90
°
.
Place the little
plates over the
runners.
Hold the doors of
the appliance and
the unit together and mark the holes.
Fig. 9
Remove the little
plates and make
the holes with a
diam. of 2 mm.
Replace the little
plates over the
runners and
screw in the
screws provided
(3.5x16 mm).
If the kitchen unit door needs to be re-aligned,
adjust the position of the screws in the slots.
At the end of the procedure, check that the doors of
the appliance and the kitchen unit open properly.
Inner door reversal
Fig. 10
Slide out pin (1).
Remove the
inner door, taking
care that pin (4)
does not fall.
Remove bush (5)
and fit it into the
opposite corner
of the door.
Remove catch (3) by undoing the screw and refit it
on the opposite side.
Move pin (4) to the hole in the opposite side of the
door.
Position the door pressing pin (1) into place.
8mm
PR34
PR35
3
2
4
1
5
PR164
