Rinse aid
Rinse aid is automatically added during the last rinse, ensuring
thorough rinsing, and spot and streak free drying.
The dispenser, which is positioned inside the door, holds about
110 ml of rinse aid, which is sufficient for 16 - 40 dishwashing
programmes, depending upon the dosage setting.
Filling with rinse aid
1. Open the container by pressing the release button (A).
2. Add the rinse aid until the container is completely full. The
maximum level for filling is indicated by "max".
Ensure that the lid is closed after every refill.
Clean up any rinse aid spilt during filling with an
absorbent cloth to avoid excess foaming during the next
wash.
Only use branded rinse aid for dishwashers. Never fill the
rinse aid dispenser with any other substances (e.g.
dishwasher cleaning agent, liquid detergent). This would
damage the appliance.
Adjusting the dose
According to the finish and drying results obtained, adjust the
dose of rinse aid by means of the 6 position selector (position
1 minimum dosage, position
6 maximum dosage).
The dose is factory set in
position 4.
Increase the dose if there are
drops of water or lime spots
on the dishes after washing.
Reduce it if there are sticky
whitish streaks on the dishes
or a bluish film on glassware
or knife blades.
Top up the rinse aid when the indicator light on the control
panel illuminates.
●
If you are using dishwasher detergent that already contains
rinse aid, the detergent including the rinse aid must be
placed in the detergent compartment.
In this case the rinse aid inflow must be deactivated in order
to avoid a double dosage.
Deactivation/activation of the inflow of
rinse aid
(The dishwasher must be switched off)
Factory setting: inflow of rinse aid activated
When the inflow of rinse aid has been deactivated, also
the rinse aid indicator light on the control panel is
automatically deactivated.
1. Press the On/Off button. All programme selection buttons
indicator lights will illuminate (setting mode).
If only one programme selection button indicator light is
illuminated, this means that a washing programme has
been selected.
The programme must be cancelled: press simultaneously
the function buttons 2 and 3 for about 2 seconds, the
indicator light of the setted programme button starts
flashing for about 2 seconds.
After about 2 seconds the indicator lights of all the
programme selection buttons will illuminate indicating that
the setted programme has been cancelled and that the
machine is now in setting mode.
2. Press simultaneously function buttons 2 and 3, the indicator
lights of the function buttons 1, 2 and 3 start flashing.
3. Press the function button 2, the indicator lights of function
buttons 1 and 3 turn off while the indicator light of the button
2 goes on flashing, at the same time the End indicator light
illuminates, indicating that the inflow of rinse aid is active.
4. To deactivate the inflow of rinse aid, press again the
function button 2, the End indicator light turns off, indicating
that the inflow of rinse aid has been deactivated.
5. To memorise the operation, switch off the dishwasher by
pressing the On/Off button or wait about 60 seconds after
which the dishwasher will automatically return to setting
mode.
To activate again the inflow of rinse aid simply follow the above
operations until the End indicator lights illuminates.
29
