12
Left hand door opening
Fig. 4
Remove the
upper right
screw and pivot.
Straighten the
safety washer (4)
of the lower right
hinge. Remove
the screw (5) and
the pivot (6)
(Fig. 3). For
safety reasons bend the washer located under the
left hinge (Fig. 4), by using a tool (for ex. a
screwdriver). Remove the right door stop hinge
(3-Fig. 3).
Inner door reversal
Fig. 5
Using a
screwdriver
release bracket
(1) by pressing on
the internal
spring (Fig. 5)
and withdraw it
from its seat
together with the
door;
remove plug (2) and fit it in the hole left open on the
opposite side;
turn the door through 180
°
, remove the bracket (1)
and refit it on the opposite side.
Refit the door and insert the top pin and bottom
bracket (1), pushing it into place.
To ensure correct storage of food, the door is fitted
with a simple spring device which holds it in the
open position until it is properly closed.
6
5
D563
4
PR140
1
2
180°
Building-in
Recess dimensions
FKE 157-4
FKE 237-4
Height
880 mm
1225 mm
Depth
550 mm
550 mm
Width
560 mm
560 mm
The appliance’s door has been locked in position for
transport by means of pins on both sides.
According to the door opening direction, remove relevant
pins at the top and at the bottom.
Fig. 6
For safety
reasons,
minimum
ventilation must
be as shown in
Fig. 6.
Attention: keep
ventilation
openings clear of
obstruction
.
Fig. 7
Air is taken in
through the
ventilation grille
at the bottom of
the appliance, but
an air outlet
“gap”, measuring
50 mm deep by
540 mm wide
(Fig. 7), must be
provided in the rear of the kitchen unit. This outlet
gap must also be kept clear between the top of the
unit and the ceiling.
Fig. 8
Slide the
refrigerator into
the unit recess
and fit the screws
into the top
bracket (Fig. 8)
and into the
bottom hinge
(Fig. 8).
50 mm
min.
cm
2
200
200 cm
2
min.
D526
D240
P
H
L
50
540
D585
