EEH 6200.0
27
Door sealing
F
The door sealing should be removed when cleaning the oven to avoid
that dirt can collect under the sealing. See page 28 “Replacing the door
sealing”.
If necessary the sealing can be cleaned with detergent or washing-up liquid.
Buttons
Clean the buttons with warm water containing a small amount of detergent,
with a damp cloth o a soft sponge.
Removing and installing the ofen door
Removing the oven door
– Open the oven door as wide as it will
go.
– Fold forward the clamps on the door
hinges.
– Take hold of the oven door on the
both sides and close it almost
completely.
– Gently lift the door and pull the
hinges forward away from the door
opening.
Reassembling the oven door
– Take hold of the oven door on both
sides and push the hinges into the
relevant holes on the oven. The hinge
will click into place.
– Slowly open the oven door full.
– Fold back the clamps on the door
hinges.
– Close the oven door.
Removing and installing the side racks
Removing the side racks
.
– Loosen the screws.
– Remove the slot-in racks.
Installing side racks
– Insert side racks and tighten down in
front.
Regenerating the ökotherm
®
catalyst
– Set the mode selector to Hot air convection
#
.
– Set temperature control to “
*
” and
– heat the empty oven for 60 minutes.
