223245
15
4.
Fitting
4.1 Electrical connections
(Connected loads and model designation: see front of the operating instructions)
This appliance may only be connected to the electricity supply by an approved electrician who must ensure
that the installation complies with the statutory regulations (Germany VDE, Austria ÖVE, Switzerland SEV,
etc.). The electrician must ensure that these regulations and those laid down by the local electricity supply
company are observed.
When connecting the electrical appliance, install an all-pole disconnecting device with a contact gap of at
least 3 mm. Make sure that the local mains voltage is the same as the voltage on the nameplate.
To connect the hob the cable has to be connected to an appliance connection socket.
Make sure that the excess cable length is not laid in the hob's installation area.
If the excess cable of this appliance is damaged, it has to be replaced by the manufacturer,
the customer service of the manufacturer or by another qualified person to avoid danger.
The connection cable must be at least HO5 RR-F.
See Fig. 4 for the position of the cable cut-out.
4.2 Maintenance and repair work
Before repair work is carried out, disconnect the appliance from the mains. If you have to contact our service
department, always quote the type and make numbers. You can find these numbers on the nameplate or on
page 1 of the Operating Instructions. Each time the glass ceramic hob is removed from the worktop, check the
seals and replace if necessary.
4.3 Working surface cut-out
Carry out all cutting out of furniture units and worktops before fitting the appliance, and remove all sawdust and
chips.
The dimensions of the worktop recess can be seen in the dimension drawing (Figs.
The worktop and the hob must be fitted horizontally. A tilted hob is under tension and this increases the danger of
breaking.
