10
PGW 4000
Assembly instructions
The barbecue-on-wheels is equipped with:
1 glass scrapper
2 ring spanners
6 screws
2 hex nuts
Setting up the Gourmet-Grill
– Attach handle and supports
as shown in the drawing
using the screws provided.
Use the 8mm ring spanners
provided to tighten the
screws.
Insert the grill assembly and tray
– Unfold the support.
– Then insert the grill assembly and tray evenly to a positive stop. The sur-
faces will then automatically be aligned parallel and horizontal.
The Gourmet-Grill is now ready to use.
Electrical connection
[
WARNING! This appliance must be earthed!
[
Make sure that the connected loads of the household comply with the
maximum voltage of the appliance (as indicated on the type plate).
[
If the barbecue shall be used in the open air, we recommend to connect
a high-sensitivity residual-current-operated-circuit-breaker (
30 mA) in
the incoming circuit. This type of breaker can be purchased from any
electrician.
[
Please note that the supply connection cable must not contact the hot
grilling surface.
■
The electrical connection is realized by means of a shock-proof plug at a
socket.
Electrical requirements (for UK and Republic of Ireland only)
■
Check that the voltage stamped on the rating plate corresponds with your
house electricity supply, which must be AC (alternating current). Electrical
connection of the apppliance must be performed by a trained electrician.
The legally recognized regulations and the connection requirements of the
electricity board seving your area must be fully complied with. When
operating the appliance outdoors, we recommend protecting it with a highly
sensitive residual current operated appliance (
30 mA), which can be
bought from any electrical fitter. Please note that the mains connection
cable should not come into contact with the hot grilling surface.
[
WARNING! Should the appliance be supplied with a continental two-pin
plug fitted, then this plug must be cut off from the connection cable. Dis-
pose of the plug safely; do not insert it in a 13 A socket elsewhere in
the house as this could cause a shock hazard.
Disassembly of the barbecue
– Pull out plug.
– Remove the grilling module and tray.
– Flap the brackets together.
Technical data
Connected load:
approx. 2.3 kW, 230 V
~
Dimensions:
L x W x H:
Grilling surface:
approx. 880 x 668 x 650 mm
approx. 410 x 360 mm