Kuppersbusch IG 6406.0E, Инструкция, Страница: 10 / 20

Rinse aid
Rinse aid is automatically added during the last rinse, ensuring
thorough rinsing, and spot and streak free drying.
The dispenser, which is positioned inside the door, holds about
110 ml of rinse aid, which is sufficient for 16 - 40 dishwashing
programmes, depending upon the dosage setting.
Filling with rinse aid
1. Open the container by pressing the release button (A).
2. Add the rinse aid until the container is completely full. The
maximum level for filling is indicated by "max".
Ensure that the lid is closed after every refill.
Clean up any rinse aid spilt during filling with an
absorbent cloth to avoid excess foaming during the next
wash.
Only use branded rinse aid for dishwashers. Never fill the
rinse aid dispenser with any other substances (e.g.
dishwasher cleaning agent, liquid detergent). This would
damage the appliance.
Adjusting the dose
According to the finish and drying results obtained, adjust the
dose of rinse aid by means of the 6 position selector (position
1 minimum dosage, position
6 maximum dosage).
The dose is factory set in
position 4.
Increase the dose if there are
drops of water or lime spots
on the dishes after washing.
Reduce it if there are sticky
whitish streaks on the dishes
or a bluish film on glassware
or knife blades.
Top up the rinse aid when the indicator light on the control
panel illuminates.
●
If you are using dishwasher detergent that already contains
rinse aid, it is necessary to deactivate the inflow of rinse aid,
in order to avoid a double dosage.
Deactivation/activation of the inflow of
rinse aid
(The dishwasher must be switched off)
Factory setting: inflow of rinse aid activated
When the inflow of rinse aid has been deactivated, the
rinse aid indicator light on the control panel is
automatically deactivated.
1. Press the On/Off button. The On/Off indicator light
illuminates (setting mode).
If a programme button indicator light is on, this means that
a washing programme has been set. The programme must
be cancelled: press simultaneously the function buttons 2
and 3 for about 2 seconds.
All the indicator lights will turn off (except for the On/Off
indicator light and eventually salt and rinse aid indicator
lights) indicating that the set programme has been
cancelled and the machine is now in setting mode.
2. Press simultaneously function buttons 2 and 3, until the
indicator lights of the function buttons 1, 2 and 3 start
flashing.
3. Press the function button 2, the indicator lights of function
buttons 1 and 3 turn off while the indicator light of the
function button 2 goes on flashing, at the same time the
indicator light End illuminates indicating that the inflow of
rinse aid is active.
4. To deactivate the inflow of rinse aid, press the function
button 2 again, the indicator light End turns off, indicating
that the inflow of rinse aid has been deactivated.
5. To memorise the operation, switch off the dishwasher by
pressing the On/Off button or wait about 60 seconds after
which the dishwasher will automatically return to setting
mode.
To activate the inflow of rinse aid follow the above instructions
until the indicator light End illuminates.
10