GCM 642.1
23
Preparing the opening for the control panel
– Fasten the two holding angles
h
on the left
and right in the control panel opening with
the screws provided. The space between the
catch points
r
must be 502 mm.
Installing the seal between hob and worktop
=
Do not seal additionally the hob frame with silicone or similar. Otherwise
the worktop can be damaged when taking off the hob.
Before the appliance is connected to electricity and gas, the self-adhesive seal
supplied separately must be installed between the hob and the worktop. This
seal is glued onto the underside of the hob frame.
After the assembly the sealing must be fitted as shown in the illustration.
1
Glass ceramic
2
Seal
3
Hob
– Press the self-adhesive sponge rubber seal around the hob frame starting
from the centre at the back.
Making the gas connection
Make the gas connection according to the information on page 21.
Installing the hob
– Insert the hob into the worktop opening. The pins on the side panelling
sheets must engage the spring catches in the hob.
– Press the hob edge by hand lightly.
Installing the control panel
– Hold the control panel in front of the prepared opening and insert the two
connection lines into the connection bushes of the control panel.
Do not use force. The shape and size of the plugs prevent them from
being inserted the wrong way round.
– Guide the electric cable of the control panel through the opening in the
bottom cupboard to the rear.
– Carefully press the control panel into the opening. The pins of the control
panel must engage the spring catches of the holding angles.
=
Attention! The all-round gap between the front of the control panel and
the cupboard front serves to ventilate the appliance and must not be
sealed.
– Insert the plug into an earthed shock-proof socket.
If the indicator lights on the control panel glow weakly when the plug is
inserted, insert the plug in the reversed way.
Before putting the appliance into operation it must be checked by the fitter for
perfect functioning and any gas leaks. The appliance is then ready for
operation.
The fitter must explain to the operator how to work the appliance on the basis
of the instructions for use. These instructions must then be handed over to
the user.
