28
EEB 960.0
What to do if trouble occurs...
=
Repairs may only be carried out by a qualified technician!
You can deal with some problems that occur yourself. First check whether
there has been any operating error. Repairs during the guarantee period are
not free of charge, when they are caused by operating errors or non-
observance of the following instructions:
Rating label
The rating label for the oven is located
on the right-hand side strip and is visible
when the oven door is open.
Always indicate the data provided on the rating label when calling in customer
service or ordering spare parts.
– Make a note of this information in case you have to consult our customer
service:
Installation instructions for fitter
■
Only KÜPPERSBUSCH built-in cookers were designed and tested for use
above a Küppersbusch fitted oven. No other cookers may be used.
■
Statutory regulations and the connection specifications issued by the local
power apply company must be strictly observed.
■
When carrying out repairs the unit must be disconnected from the mains
(switch off the fuse or unplug from the mains).
■
It must not be possible to touch components which are insulated under
operating conditions.
■
The earth wire must be so long that if the mains lead cleat fails, the live
wires of the connecting cable are subjected to tension before the earth wire.
■
The unit is ready to plug in and may be connected only to a properly installed
protected socket. Installing and wiring a socket or replacing the connection
cable should only be performed by an electrician and in observance of the
relevant regulations. If the socket is too far away to reach from the installation
location, safety regulations require that an all-pol isolator with a contact
opening of at least 3 mm be used on the installation side.
■
The socket for plugging in the unit must be outside the installation space.
■
If you install the EEB 960.0 flush-left into the corner of an L-shaped divided
kitchen, you must maintain a distance of at least 15 cm to the left or the
corner!
■
Based on test determinataions for heating the device corresponds to
Protection Class Y.
■
Built-in kitchen fixtures must be temperature resistant to 100 °C. This
applies especially to veneers, plastic coatings, adhesives and varnishes.
Adjacent cabinetry front must be temperature resistant to at least 70 °C.
■
The unit must be installed absolutely horizontal on a level, solid base. The
base must not be allowed to sag.
■
If the cupboard element is not attached to the way, screw on using an
ordinary bracket.
Installation dimensions
Fault
Cause
Remedy
Clock flashes “0.00” and
oven does not function.
Clock is not set –
occurs at startup or
after power
interruption.
Set clock. (p. 19)
Not possible to switch off
the oven.
Electronic component
defective.
Disconnect fuse, call the
service centre.
Oven does not heat up.
Fuse defective.
Check and replace fuse, if
nessesary.
Oven temperature
control or function
switch has not been
switched on.
Set oven temperature control
or function switch as
required.
Oven light no longer works. Lighting defective.
Ask customer service about
changing the light bulb.
Mode display or heating-up
display does not light up.
Lighting defective.
Have customer service
replace lamp.
Glass of oven door broken.
Switch off the appliance,
call customer service.
Strong smells from oven in
spite of ökotherm
®
-
catalyst.
ökotherm
®
-catalyst
must be regenerated.
Heat the empty oven by
intensive hot air convection
at 275 °C for 60 min.
Strong vinegar smell when
preparing.
Sour doughs, yeast
doughs, dishes with
alcohol.
Unavoidable odours.
Fruit juice or protein stains
on enamelled parts.
Moist cake or meat
juices.
Harmless changes in the
enamel, cannot be remedied.
Production-no.:
Model designation oven:
