Kuppersberg NRB 17761, Руководство пользователя, Страница: 17 / 48

17
english Technical passporT
refrigerator nrB 17761
WARNING: THIS APPLIANCE
MUST BE EARTHED
If the appliance has been tted with
a non-rewirable plug of the incorrect
type for the mains socket, cut off the
plug and t a new one. The removed
plug must be thrown away. Inserting
an unsuitable plug into a 13 Amp
socket is likely to cause an electrical
hazard. When a non rewirable plug
or rewirable 13 Amp (BS1363) plug is
used, it must be tted with a 15 Amp
A.S.T.A. approved (BS1362) fuse. If any
other type of plug is used it must be
wired as follows. Connect the GREEN
& YEL LOW wire to the earth terminal
marked with the letter “E” or earth
symbol,
or coloured green or green
& yellow. Connect the BLUE wire to
the neutral terminal marked with the
letter “N” or coloured black. Connect
the BROWN coloured wire to the live
terminal marked with the letter “L” or
coloured red.
If the appliance has no plug
attached, it must be connected to
the electricity supply by installing a
switch which is directly connected to
the mains. This switch must ensure
omnipolar disconnection under
overvoltage category III conditions.
TROUBLESHOOTING
1) THE APPLIANCE DOES NOT
WORK.
Â
Is there a power cut?
Â
Is the plug inserted properly in
the mains socket?
Â
Is the power supply cable
damaged?
Â
Is the temperature setting
correct?.
2) THE TEMPERATURE INSIDE
THE COMPARTMENTS IS NOT
LOW ENOUGH.
Â
Do the doors close properly?
Â
Is the appliance installed near to
a heat source?
Â
Is the temperature setting
correct?.
Â
Is the condenser clean?
3) THE TEMPERATURE INSIDE
THE FRIDGE COMPARTMENT IS
TOO LOW.
Â
Is the thermostat in the right
position?
4) THE APPLIANCE IS VERY
NOISY.
Â
Is the appliance in contact with
other furniture or objects?
Â
Are the pipes on the back
touching or vibrating?
Â
Is the appliance level?
5) THE INTERNAL LIGHT DOES
NOT WORK
Â
Contact the ASSISTANCE
SERVICE.
6) WATER IS FOUND ON THE
FLOOR.
Â
Is tray V placed correctly and
contacting the compressor surface?
Â
Is discharge tube R placed
correctly inside the tray?