Kuppersberg HGG 663 B, Технический паспорт

Страница: 8 / 36

8
TEchnical passporT English
gas oven
Installing The Appliance
It is important that all installation
procedures be performed by a qualifi ed
technician. After unpacking the oven to
connect it, rest it on its base without
damaging it.
Do not lift the oven by yhe door
handle, but hold it at the sides.
Do not lift the oven by the gas
connection. Make sure that the appliance
has not been damaged during transport,
Oven dimensions and kitchen unit
dimensions are shown in the opposite
fi gure.
Kitchen units in contact with the
oven must be heat resistans: min. 75°C
above ambient temperature during
periods of operation. House the oven
in the unit cavity, lifting it at the sides
and making sure that the supply cable
is not trapped. For correct ventilation,
follow the ventilation opening directions
shown in the fi gure, secure the oven to
the kitchen unit with the screws.
Before Installation. Comments

To unpack the oven, pull the
tab located on the lower part of the
box and to move it, hold by the lateral
handles and never by the oven door
handle.

A nichle is required in the
kitchen unit as per the dimensions shown
on the fi gure, pro viding a minumun
depth of 580 mm. (See fi gures 4 and 5
describing oven fi tting on the page 68).

To fi t multifunction ovens in
their locations, the back part of the unit
corresponding to yhe shaded area of
fi gure 6, must not have any projections
(reinforcements, pipes, sockets, etc). (See
the page 68).

The adhesive used for the
platic covering of kitchen furniture must
be able to withstand temperatures up to
58°C.
Notes
Use of gas cooking appliance produces heat and moisture in the room in which
it is installed. The room must therefore be well ventilated by keeping the natural air
vents clear (fi g. 1) and by acti vating the mechanical aeration device (suction hood or
electric fan fi g. 2 and fi g. 3). Intensive and lengthy use of the appliance may require
additional ventilation. This can be achieved by opening a window or by increasing
the power of the mechanical exhausting system if installed.