Kuppersberg GS 6005, Технический паспорт, Страница: 21 / 64

21
ENGLISH TECHNICAL PASSPORT
Dishwasher
NOTE:
If operate from step 1 to step
2, the fi lter system will be removed;
while operate from step 2 to step 1, the
fi lter system will be installed.
Filter assembly
For best performance and results,
the fi lter assembly must be cleaned. The
fi lter effi ciently removesfood particles
from the wash water, allowing it to
be recirculated during the cycle. For
this reason, itis a good idea to remove
the larger food particles trapped in
the fi lter after each wash cycle by
rinsingthe semicircular fi lter and cup
under running water. To remove the
fi lter assembly, pull on the cuphandle
in the upward direction. The entire
fi lter assembly should be cleaned once
a week. To cleanthe coarse fi lter and
the micro fi lter, use a cleaning brush.
Then, reassemble the fi lter parts as
shownin the fi gures above and reinsert
the entire assembly in the dishwasher,
positioning in its seat andpressing
downward. The dishwasher must never
be used without the fi lters. Improper
replacementof the fi lter may reduce the
performance level of the appliance and
damage dishes and utensils.
WARNING!
Never run the dishwasher without
the fi lters in place. When cleaning the
fi lters, don’t knock on them. Otherwise,
the fi lters could be contorted and the
performance of dishwasher could be
debased.
Cleaning the Spray Arms
It is necessary to clean the spray
arms regularly for hard water chemicals
will clog the spray arm jets and
bearings.
To remove the spray arms, screw
off the nut clockwise to take out the
washer on top of the spray arm and
remove the arm. Wash the arms in
soapy and warm water and use a soft
brush to clean the jets. Replace them
after rinsing thoroughly.