Kunft KSM2612, Инструкция по эксплуатации

Страница: 19 / 76

18 19
KSM2612
2.2.17. Zipper sewing
Zipper sewing requires the zipper presser foot [39].
1. Change the zipper presser foot [39] according
to the instructions described on 2.5. (The
zipper presser foot can be installed on both left
and right sides according to your convenience.)
2. rotate the hand wheel [27] to lift the sewing needle [17] to the
highest position and then adjust the function adjustment wheel [3]
to function 1 or 2.
3. Lift the presser foot and unzip the zipper to make the zipper teeth
of a single side well matched with the fabric. Put them under the
presser foot and place the pinpoint of the sewing needle [17] 6-8
mm away from the zipper edge. Move the presser foot lifter [32]
downwards to lower the presser foot.
4. Stamp the foot switch [35] gently to start sewing.
5.
When sewing up to the zipper head, stop the sewing machine
to take out the sewing fabric and move the zipper head to the
previously sewed position so to avoid uneven zipper head sewing.
Then continue sewing. Sew the other side of the zipper using the
same method. Pay attention to the match between the two sides
of the zipper.
2.2.18. Reverse
Press the reverse button when finishing sewing
and sew several stitches to strengthen them
and avoid stitches from becoming loose, as
shown in below Fig. Reverse stitches shall not
exceed 5 cm. Release the reverse button and
the sewing machine will start sewing forward
again.
2.2.19. Thread cutting
use the thread cutter [26] to cut the thread, as
shown in below fig.
EN
sewing machine
Maq-Costura-KSM2612-Manual-2.indd 19 18/02/19 18:34