12
13
If necessary, slightly loosen the set screw (11) by turning it
anticlockwise. Slide the switch box (10) down over the inner tube
(12) and tighten the set screw (11). make sure the set screw (11) is
tightly secured.
2.2.2. Blade and Grill assembly
1.
unscrew the plastic mounting nut (4) from the front of the motor
housing (8) by rotating it anticlockwise.
2.
Position the rear grill (5) against the front of the motor housing (8) with
the handle uppermost, ensuring that the locating pegs on the motor
housing (8) are engaged correctly in the holes of the rear grill (5).
3.
Tighten the rear grill mounting nut (4) clockwise. Do not over
tighten it.
4.
Push the fan blade (3) on to the motor shaft (6), locating the slot
at the back of the blade on the drive pin that passes through the
motor shaft (6).
5.
Tighten the blade cap (2) by turning it anticlockwise.
6.
Position the front grill (1) against the rear grill (5) so that the holes
in the rims that accept the small nut and bolt are in line. Insert the
bolt through the holes and screw on the nut. Do not fully tighten
at the stag.
7.
Push the grill retaining clips into position ensuring that they engage
correctly on the rim of the grill.
8.
fully tighten the small nut and bolt that passes through the rim of
the grill.
2.3. operating Instructions
1.
Place your fan on a level and dry surface.
2.
Plug the fan into the mains socket. Select the desired speed
setting. There are 4 speed settings:
0
- The fan is switched off.
1
- The fan operates at the lowest speed.
2
- The fan operates at medium speed.
3
- The fan operates at high speed.
3.
The fan can be set to oscillate by pushing the oscillating knob
downwards. To stop the oscillating feature, pull up the oscillation
knob.
4.
To adjust the tilt angle of the fan head, loosen the neck screw,
swivel the fan to the desired angle and then re-tighten the screw.
Caution:
The fan should always be switched off when performing
this adjustment.
Ventoinha-KSF2374-Kunft-Manual-2.indd 12
17/12/20 14:48
