CO2 CONTROL - assembly and operating instructions
-11-
2.6
Installing the AM / AM PLUS add-on module
(see
CO2 CONTROL AM / AM PLUS
assembly instructions)
2.7
Installing the distributor
The distributor housing is screwed to the wall using two screws/dowels. In order to seal the housing, the screw penetration points (1) are sealed with the included plugs. Alternatively,
the distributor can also be attached to the wall using external brackets (2).
The lid can be secured with the included retaining strap to prevent it falling down (3).
The control cables can be simply pushed through the penetration membrane (IP 66) (4).
If a higher IP class than IP66 is necessary then an M20 screw connection must be used (not included in the scope of delivery). To do this, remove the membrane completely and add the
M20 screw connection in its place (5).
1
2
4
3
5
