KUHN AXIS 20.1, Руководство оператора

Страница: 95 / 216

Spreading Operation
83
B
AXIS
20.1
AXIS
20.1
B.2 Using the calibration charts
B.3 Spreading at the headland
B.4 Setting the application rate
For the solid fertiliser broadcaster AXIS 20.1, the application rate can be set at
both openings by the lower scale plate.
The operator moves the pointer to the position specified beforehand in the cali-
bration charts or by a calibration test. This is the
Open stop position at which the
slide approaches hydraulically or by spring force (depending on the version) while
spreading.
The position depends on the
application rate and the ground speed .
NOTICE
Please note chapter 8. 6: Using the spreading calibration chart, page 52 .
NOTICE
Please note chapter 8. 7: Spreading at the headland, page 59 .
NOTICE
The solid fertiliser broadcaster AXIS 20.1 Q is fitted with an electric slide actua-
tor for the setting the spreading volume.
The electric slide actuator is described in a separate operator's manual for the
electronic control system. This operator 's manual is part of the electronic con-
trol system.
n
CAUTION
Observe the position of the metering slide
Operation of the actuators via the Quantron E can cause damage
to the metering slide if the stop levers are incorrectly positioned.
 Always clamp the stop lever at the maximum position on
the scale.