KUHN AXIS 20.1, Руководство оператора

Страница: 94 / 216

Spreading Operation B
82
AXIS-GENERAL
AXIS
20.1
B Spreading Operation
B.1 Safety
The following points should be noted before carrying out adjustments on
the machine:

Volume setting is always carried out with the slider closed. With slide controls
using return springs (versions K + R) the ball-cocks must be closed.

Close the ball-cocks (versions K + R) in order to prevent inadvertent escape
of fertiliser from the hopper e.g. during road travel.
n
DANGER
Danger from running engine
Working on the solid fertiliser broadcaster with the engine running
can lead to serious injuries caused by mechanical components or
escaping fertiliser.
Wait until all rotating parts have come to a complete stop before
making any adjustments.
 Turn off tractor. Remove the ignition key.
 Direct all persons out of the danger zone.
n
CAUTION
Danger of crushing or shearing by tensioned return springs,
versions K + R (single-acting slide control)
If the metering slide is not closed hydraulically, it can result in the
loosening of the retaining screw, which will cause the pre-ten-
sioned stop lever to snap back hard against the end of the guiding
slot.
In the event of misuse or non-observance of the procedure for set-
ting the spreading volume, the stop lever can snap back forcefully
and unexpectedly to the end of the guide slot.
This can cause crush injuries to the fingers of the operator.
 Never push against the spring pressure by hand to hold the
stop lever in position during volume setting.
 Before starting any kind of tuning or calibration tasks (e.g.
setting of the spreading material volume), always close the
metering slide
hydraulically .