8
4.4.
Unpacking
Note: Before unpacking check the damage is whether due to the transportation or not, if you
find any such damage, please do not use this item, and contact with the dealer or manufacturer
as soon as possible.
•
Open the fly-case, and discover the inside plastic bag.
•
High-lift the product by two handles beside the bottom base and move it out.
•
Before power on, make sure you have opened the X, Y axis lock!
5.
Install standard
5.1.
Install lock
HOT BEAM 150 LED can be placed on the stage, or mounted in an arbitrary direction of the
truss. Two fast locks system could fix the item easily.
5.2.
Equipment fixed
•
Before installation must verify the fast lock is keep in good state, and can withstand at least
10 times the weight of product. Verify that the building can withstand at least 10 times of
the total weight of the product and accessory
equipment’s
.
•
Fix the hang fixture into the hole, which located on the base of the price.
•
Seize handle of fasteners, clockwise rotate 1/4 turn and lock. Installed other one fastener in
the same method.
•
Using the safety cable which can withstand 10 times the weight of the equipment.
•
Make sure the X, Y protect locks are opened, verify that within 3 meters there is no
combustibles.
WARNING
Fixture must use two fixing devices, and make sure the fixing device have locked!
And only fully clockwise rotate 90 ° can lock the hang fixture! Do remember plus a
safety rope, and do not connect the safety rope to plastic handle. It should be
connected to the hole on the base!
5.3.
Fixture connects
Attention! One product only can accept one input one output.
HOT BEAM 150 LED
DMX cable include 3 contact pins:
Pin 1, FOR GROUND;
Pin 2 connected to the negative polarity signal; The pin 3 connected to the
positive polarity signal.
DMX512 cable must use the professional shielded twisted pair cable; standard loudspeaker cable
is not reliable to control the long-range data. 24AWG cable is suitable for more than 300 meters
long-distance signal transmission and must add\ DMX 512 signal amplifier.
Do not use two outputs to separate the connection, if separate a continuous connection to
branch, DMX512 splitter is necessary.
If use the DMX512 splitter. At first connect DMX512 Splitter input terminal to controller, and
