FIT WATER DELIVERY COLUMN
Ensure all component parts are fitted to the relevant tubes before securing to curved glass panel.
Fit plug connector to TOP of Water Outlet Body, ensuring the rubber washer is fitted.
Feed flexible hose through 945mm long bottom tube and connect to BOTTOM of Water Outlet Body, ensuring
rubber washer is fitted.
Assemble all component parts to 910mm long top tube.
Fit tubes into Water Outlet Body ensuring these are fully home and secure using the 4 grub screws.
Secure fully assembled column to glass panel using screws through holes in glass, ensuring all protective
washers are fitted.
Remove protective film from underside of shroud and press firmly down onto tray to achieve watertight seal.
Note: the remaining 945mm long extension tube is not required for this water supply.
Make 25mm hole in ceiling directly above column.
Fit plug connector to BOTTOM of Water Outlet Body, ensuring the rubber washer is fitted.
Feed flexible hose through extension tube (cut tube to length if necessary), top spacer collar assembly and
910mm long tube and connect hose to TOP of Water Outlet Body, ensuring rubber washer is fitted.
Fit tubes into Water Outlet Body ensuring these are fully home and secure using the 4 grub screws.
Secure fully assembled column to glass panel using screws through holes in glass, ensuring all protective
washers are fitted.
Remove protective film from underside of shroud and press firmly down onto tray to achieve watertight seal.
Repeat to fit shroud to ceiling.
Note: the tube cover cap is not required for this water supply.
30
UNDER-TRAY WATER SUPPLY
OVERHEAD WATER SUPPLY
UNDER-TRAY
WATER SUPPLY
OVERHEAD
WATER SUPPLY
V10 2