PREPARE ELECTRICAL WIRING
WARNING:
FOR PERSONAL SAFETY:
Remove house fuse or open circuit
breaker before beginning installation.
Do not use an extension cord or adapter
plug with this appliance.
Electrical Requirements:
• This appliance must be supplied with 120V / 60 Hz.,
and connected to an individual properly grounded
branch circuit, protected by a 15 or 20 ampere circuit
breaker or time delay fuse.
• Wiring must be two wire with ground.
• If the electrical supply does not meet the above
requirements, call a licensed electrician before
proceeding.
Grounding Instructions
This appliance must be connected
to a grounded metal, permanent wiring system, or an
equipment grounding conductor must be run with the
circuit conductors and be connected to the equipment
grounding terminal or lead on the appliance.
WARNING:
Improper connection of the equipment
grounding conductor can result in a risk
of electric shock. Check with a qualified
electrician or service representative if
you are in doubt that the appliance is
properly grounded.
Cabinet Preparation & Wire Routing:
• The wiring may enter the opening from either
side, rear or the floor within the shaded area.
• Cut a 1-1/2”(38.1mm) max. dia. hole to admit the electrical
cable. The hole must be free of sharp edges. If
the cabinet wall is metal, the hole edge must be
covered with a bushing/grommet.
• Cable direct connections may pass through the
same hole as the drain hose and hot water line,
if convenient.
Electrical Connection to Dishwasher:
• The electrical connection is located on the right
front side of the dishwasher.
• The cable must be routed as shown in Fig. 5
Cable must extend a minimum of 24”(609.6mm) from the
rear wall.
4
1-1/2”(38.1mm) Dia
Hole
3“(76.2mm)
24”(609.6mm)
Wall
Installation Preparation
Содержание K6502D
Страница 7: ......
