FOR MORE DETAILS AND INFORMATION, PLEASE VISIT OUR WEBSITE
WWW.KUCHT.COM
INSTALLATION GUIDE AND USER MANUAL
Operative Mode
Always leave safety grills and filters in place. Without the presence of these blowers hair,
fingers or clothing could catch. The manufacturer is not liable if the suggested steps
detailed in this manual for installation info, maintenance and proper use of the product are
not observed. The manufacturer declines all responsibility for any injury caused by
negligence. This product is manufactured for internal use. Do not use this appliance
outdoors.
Electrical requirements and installation requirements
Power Requirements
IMPORTANT
Observe all governing codes and ordinances. The customer is responsible for: Contacting
an electrician-installer. Check that the electrical installation is adequate and in
conformance with the National Electrical Code, ANSI / NFPA 70 (latest edition *) or CSA
Standards C22.1-94, Canadian Electrical Code, Part 1 and C22.2 No.0-M91 (the latest
edition **) of the CSA, and all codes and ordinances in your area. If codes permit and use
a wire to separate the ground, it is recommended to check the path of the wire by an
electrician. Do not put the device to land on a gas line. Consult a qualified person if you
are not sure that the hood is properly grounded electrically. Do not install a fuse in the
neutral circuit or circuit ground.
Location of the electrical installation
• The cable must enter the rear wall at least 20 to 1/4 "above the height of the installation
base, and between 7-5/8" and 4-7/8 "from the left side of the mid-line.
IMPORTANT
Keep these instructions in order to return them to the electrical inspector. The hood must
be plugged directly into a 110 volt wall outlet.
