3. fixed range hood
Good installation height is calculated according to Figure 1, the first Φ10 drill
on the wall (as shown in Figure 2) drilled distance
From 260mm two holes and maintain the level of the hole depth of 50 mm.
Then away from the ceiling 10mm at Φ6 the drill drilled distance and maintain
the level of the two holes of 250mm, the hole depth
40mm. (Please ensure that the four-hole centerline on the same line) steel ex
-
pansion bolts (No. 6) stuffed into the hole, remove the above M6 nut and
washer, and range hood vertical hanging wall steel expansion tighten the nut
on the bolts, and then loaded on the M6 nuts and washers, and then adjust the
angle range hood fixed. Wind shield and rubber pad and remove the four
screws (No. 3), a wind shield and rubber pads on the range hood vent with
screws, remove the duct (No. 2) Plug one end of the hood The slot reuse alu-
minum foil tape (No. 10) circumferentially stuck, the other end is fixed on the
public flue or direct access to the outdoor.
Figure 2
250
Installation Instructions
Installation Instructions
7
6
(Figure 1, in mm)
No.
Name
Quantity
1 Range Hood
1 set
2 A duct
A
3 Out of the wind cover
1 set
4 Both interior and
exterior cover
1 set
5 Fixation
A
6 Steel expansion bolts
M6*5
0
2 sets
No.
Name
Quantity
7 Plastic Expanding
Φ
8*35
2 sets
8 Wood scre ws ST4.2*38 2 sets
9 Oil Cup
1 set
1
0
Aluminum foil tape
6
00
*5
0
m
2 sets
11 Cross slot big flat
head screws M4*8
2 sets
12 instruction manual
A
Содержание HCF Series
Страница 1: ...Cooker Hoods Instruction Manual...
