Kubota ZG327A-AU, Руководство оператора

Страница: 80 / 104

63 PERIODIC SERVICE
3. Fluid escaping from pinholes may be invisible. Use a
piece of cardboard or wood to search for suspected
leaks: do not use hands. Use safety goggles or other
eye protection.
If injured by escaping fluid, see a medical doctor at
once. Serious infection or reaction will result if proper
medical treatment is not administered immediately.
This fluid can produce gangrene or severe allergic
reaction.
B
Replacing Transmission Oil Filter [HST]
To avoid personal injury:
A
Be sure to stop the engine and remove the key
before changing the oil filter.
A
Allow transmission case to cool down
sufficiently; oil can be hot and may cause
burns.
1. The oil filter must be changed every 200 service hours.
2. Place an oil pan underneath the oil filter. (Do not drain
oil.)
3. Remove the oil filter by using the filter wrench.
4. Apply a slight coat of oil onto the gasket of new filter.
5. Tighten the filter quickly until it contacts the mounting
surface. Tighten filter by hand an additional 1/2 turn
only.
6. After the new filter has been replaced, the
transmission fluid level normally lowers a little. Add
fluid to proper level. Check for oil leaks around filter
gasket.
A
To prevent serious damage or premature failure to the
hydraulic system, use only a KUBOTA genuine filter.
(1) Cardboard
(2) Hydraulic line
(3) Magnifying glass
(1) Transmission oil filter [HST]
(1) Transmission oil filter [HST] (2) Gasket