Kubota WSM L4400, Руководство по ремонту, Страница: 28 / 31

L4400, WSM GENERAL
G-15
Replacing Hydraulic Oil Filter
A
Be sure to stop the engine before changing the oil filters.
A
Allow engine to cool down sufficiently, oil can be hot and
can burn.
1. Place an oil pan under the tractor.
2. Remove the drain plugs (1) at the bottom of the transmission
case.
3. Drain the transmission fluid.
4. After draining, reinstall the drain plugs.
5. Remove the oil filter cartridge (4) by using a filter wrench.
6. Make sure the mounting surface is clean.
Put a film of clean transmission fluid on the rubber seal of the
new filter.
7. Install the new filter cartridge.
8. Quickly tighten the filter until it contacts the mounting surface,
then tighten it by hand an additional 1/2 turn only.
9. After the new filter have been replaced, fill with oil up to the
upper line of the gauge (2).
10. After running the engine for a few minutes, stop it and recheck
the oil level, add oil to the prescribed level.
11. Make sure that the transmission fluid doesn't leak through the
seal of the filter.
A
To prevent serious damage to the hydraulic system. Use
only a genuine KUBOTA filter or its equivalents.
Changing Front Axle Case Oil [4WD]
1. Place the oil pans underneath the front axle case.
2. Remove the drain plug (1) both sides and filling port plug (3) to
drain the oil.
3. After draining, reinstall the drain plug.
4. Remove the oil level check plug (2).
5. Fill with the new oil up to the check plug (2) port.
6. After filling, reinstall the check plug (2) and filling port plug.
A
Use KUBOTA SUPER UDT fluid or SAE 80, 90 gear oil.
Refer to "LUBRICANTS, FUEL AND COOLANT". (See
page G-8.)
(1) Drain Plug A : Oil level is acceptable within
(2) Gauge this range.
(3) Filling Plug
(4) Hydraulic Oil Filter
0000008226E
Front axle case oil Capacity
6.5 L
6.9 U.S.qts
5.7 Imp.qts
(1) Drain Plug (3) Filling Port Plug
(2) Check Plug
0000008227E
KiSC issued 04, 2006 A