4
4. Installation instruction
To avoid personal injury or death:
A
Park the machine on a firm and level ground
and set the parking brake.
A
Lower the bucket to the ground.
A
Set all controls in their neutral positions.
A
Release all residual pressure of the hydraulic
system.
A
Stop the engine. Remove the key from the
ignition.
A
The engine, hydraulic components and
coolants can be hot. Wait until all the
components are cooled down sufficiently to
avoid burns.
A
Clean the work area and the machine.
A
Disconnect the battery negative cable.
A
Hang a "DO NOT OPERATE" tag on the
operator station.
A
Put on working clothes and personal protective
equipment.
A
Read all instructions and safety instructions in
this bulletin and safety labels on your machine.
A
Follow the local safety regulations and/or laws
in your country.
A
If you are working with other people, make sure
that your signals and communications are fully
understandable for additional safety.
A
Do not contact fuel tubes to sharp edges, high
temperature parts, and rotating parts.
A
Do not stretch fuel tubes excessively.
A
Do not clamp fuel tubes with electrical wiring.
A
Do not flatten fuel tubes by the clamps.
A
Take care not to leak fuel when disconnecting fuel
tubes.
A) Preparation
After the following steps 1 to 5, install the necessary parts
according to the installation manual B), C) and D). If
necessary for the details, see the WSM.
1. Open the rear and upper bonnet (1) (3).
A
Insert the pin (2) into the locked position (A) to fix the
rear bonnet.
(1) Bonnet (Rear)
(2) Pin
(A) Locked position
(3) Bonnet (Upper)
Содержание V0621-9860
Страница 2: ...2 ...
