Kubota T1880, Руководство оператора

Страница: 37 / 73

22 OPERATING THE MOWER
OPERATING THE MOWER
MAKING THE MOST OF YOUR MOWER
1. When using your mower for the first time, choose a
smooth level area and cut in straight and slightly
overlapping strips.
2. The size and type of the area to be mowed will
determine the proper mowing pattern. Take into
account obstructions, such as trees, fences and
buildings. To keep grass clippings off fences,
sidewalks, etc., it is advisable to go over the outside of
the area to be mowed several times in a clockwise
direction. To mow the area remaining, work in a
counterclockwise direction so that the clippings are
dispersed onto the previously cut area.
3. Always keep the left side of the mower toward trees,
posts or other obstacles on the first trip around the
obstacle.
4. Most lawns should be mowed to keep the grass
approximately 50 to 80 mm (2 to 3 in.) high. Best
results are obtained by cutting often and not too short.
To keep a green lawn, never mow more than one third
of the height of the grass or a maximum of 25 mm (1
in.) in one mowing.
For extremely tall grass, set the cutting height at
maximum cutting height for the first mowing, then
reset to the desired height and mow again. Allow the
grass to grow to 80 mm (3 in.), then cut off only the top
inch.
5. For best appearance, grass should be cut in the
afternoon or evening when it is free of moisture.
To avoid personal injury:
A
Clear the work area of objects which might be
picked up and thrown by blades.
A Keep bystanders and animals away from the
mowing area.
A
Be sure to disengage the PTO and sit on the
operator's seat before starting the engine.
ADJUSTING CUTTING HEIGHT
To avoid serious injury or death:
A
Do not operate mower in the "TOP" position.
B
Cutting Height Control Dial
Raise the lift lever to the top position. Turn the cutting
height control dial to the desired cutting height. Then
lower the lift lever and the mower deck will be set to the
cutting height.
1. Before adjusting the cutting height, check that all tire
pressures are correct. If necessary, adjust to the
correct tire pressure.
2. To set the cutting height, pull the mower lift lever up to
raise the mower deck to the "TOP" position.
3. Turn the cutting height control dial to adjust the height.
4. Set the anti-scalp rollers' height as shown to keep
clearance between rollers and ground more than 6
mm (0.25 in.).
(1) Cutting height control dial
(2) Lift lever "RAISE"
"LOWER"