Kubota RTV 400 CAB, Инструкция по установке и эксплуатации, Страница: 7 / 18

2.1 Fig. 2.1 shows the only item included in the wind-
shield kit. Note: inside view of windshield assembly shown.
2.2 Orient the windshield as shown in fig. 2.1. Hook the
two upper pins into the receiving slots in the front of the up-
per mounts (see fig. 2.2). Snap the lower two latches onto
the pins on the inside of the front mounts until they are fully
engaged. Two (2) clicks means fully engaged. If adjustment
is needed, use a 3/16” Allen wrench and a 1/2” open ended
wrench to reposition the pin in the slotted front mount.
2.3 Three areas are adjustable if a better seal is desired.
First be sure that the upper pins are seated at the bottom of
the receiving slots in the upper mounts before beginning any
adjustments. The lower latches have adjustment in and out
(see fig. 2.3). The lower pins on the front mounts have ad-
justment up and down. The upper pins have adjustment in all
directions due to an oversized hole. Make the necessary ad-
justments until you achieve “double click” engagement. If
the issue is with the seal against the ROPS tubing, adjust the
lower latches in or out. If the issue is with the seal against the
hood, adjust the pins up or down.
p. 7 of 18
WINDSHIELD KIT (p/n: V4368 / 77700-V4368)
Note: Mount Kit (p/n: V4310) is required
in order to mount this windshield kit.
Fig. 2.2 (description of slot usage)
ref.: slots for roof installation
slots for windshield installation
Fig. 2.3 (view from inside of driver’s side)
use an Allen wrench here to adjust
slotted
for
adjust-
ment
Fig. 2.1 (contents of windshield kit)