85
PERIODIC SERVICE
B
Replacing Slow-Blow Fuses
The slow-blow fuses are intended to protect the electrical
cabling. If any of them has blown out, be sure to pinpoint
the cause. Never use any substitute, use only a KUBOTA
genuine part.
C
Replacement procedure
[100 Amp. Slow-blow fuse]
1. Disconnect the negative cord of the battery.
2. Remove the vinyl tape on the wire harness.
3. Detach the slow blow fuse case cap.
4. Pull out the slow-blow fuse assy from the fuse case.
5. Open the cover, remove the bolts and draw out the
slow-blow fuse.
Fuse
No.
Capacity
(A)
Protected circuit
(1)
20
Side Window Defogger
(2)
20
Rear Window Defogger
(3)
10
4WD / Bi-Speed Turn
(4)
10
4WD brake
(5)
15
Work Light (Rear)
(6)
15
Work Light (Front)
(7)
15
Cigarette Lighter
(8)
20
Air Conditioner (Fan Motor)
(9)
10
Air Conditioner (Compressor)
(10)
15
Work Light (Front, Side)
(11)
15
Auxiliary Power
(12)
5
Starter Relay
(13)
5
Radio
(14)
5
Air Conditioner (Control)
(15)
15
Wiper
(16)
5
Alternator, Engine, PTO, Heater
(17)
5
Meter Panel, OPC
(18)
10
Turn Signal, Stop Lamp
(19)
10
Meter, Radio (Back Up)
(20)
20
Head Light, Position Lamp
(21)
20
Flasher (Hazard)
(22)
20
Spare Fuse
(23)
50
Head Light, Hazard
(24)
50
Air Heater
(25)
100
Charge
(26)
30
Electrical Outlet
(27)
40
Air Conditioner
(28)
30
Work Light, Fuel Cut Solenoid
(29)
30
Key Switch
(1) Vinyl tape
(2) Slow blow fuse case cap
(1) Slow blow fuse assy
(2) Fuse case
(1) Cover
(2) Bolt
(3) Slow-blow fuse
