Kubota M5-091, Руководство оператора

Страница: 113 / 176

89 PERIODIC SERVICE
B
Checking Head Light, Turn Signal / Hazard
Light etc.
1. Inspect the lights for broken bulbs and lenses.
2. Replace if broken.
B
Checking Seat Belt and ROPS
1. Always check condition of seat belt and ROPS
attaching hardware before operating tractor.
2. Replace if damaged.
B
Checking Movable Parts
If any of the movable parts, such as levers and pedals, is
not smoothly moved because of rust or sticky material, do
not attempt to force it into motion.
In the above case, remove the rust or the sticky material,
and apply oil or grease on the relevant spot.
Otherwise, the machine may get damaged.
INITIAL 50 HOURS
B
Changing Engine Oil
(See "Changing Engine Oil" in "EVERY 500 HOURS" in
"PERIODIC SERVICE" section for this service.)
B
Replacing Engine Filter
(See "Replacing Engine Oil Filter" in "EVERY 500
HOURS" in "PERIODIC SERVICE" section for this
service.)
EVERY 50 HOURS
B
Checking Engine Start System
To avoid personal injury or death:
A Do not allow anyone near the tractor while
testing.
A
If the tractor does not pass the test, do not
operate the tractor.
C
Preparation before testing.
1. Place all control levers in the "NEUTRAL" position.
2. Set the parking brake and stop the engine.
C Test: Switch for the shuttle shift lever.
1. Follow the instruction of "PARKING THE TRACTOR".
(See "PARKING THE TRACTOR" in "SAFE
OPERATION" section.)
2. Sit on the operator's seat.
3. Shift the shuttle shift lever to the forward or reverse
position.
4. Depress the clutch pedal fully.
5. Disengage the PTO clutch control switch or lever.
6. Turn the key to "START" position.
7. The engine must not crank.
8. If it cranks, consult your local KUBOTA Dealer for this
service.
C Test: Switch for the PTO clutch control switch or
lever.
1. Follow the instruction of "PARKING THE TRACTOR".
(See "PARKING THE TRACTOR" in "SAFE
OPERATION" section.)
2. Sit on the operator's seat.
3. Engage the PTO clutch control switch or lever.
4. Depress the clutch pedal fully.
5. Shift the shuttle shift lever to the neutral position.
6. Turn the key to "START" position.
7. The engine must not crank.
8. If it cranks, consult your local KUBOTA Dealer for this
service.
With a new machine, be sure to do the servicing, as
discussed below, after the first 50 operating hours.