Kubota M4N-071, Руководство оператора

Страница: 84 / 152

(1) Lifting rod (A) “GROOVE”
5. Lifting rod (right)
WARNING
To avoid personal injury or death:
• Do not extend lifting rod beyond the groove on
the threaded rod.
1. To adjust the length of the lifting rod, lift the
adjusting handle and turn to desired length.
2. After adjusting, the lifting rod adjusting handle must
be returned and stored in the fore and aft position.
3. When extending the rod using the adjusting handle,
do not exceed the groove on the rod thread.
(1) Lifting rod
(2) Adjusting handle (A) “GROOVE”
(1) Adjusting handle
(2) Lock pin
(A) “LOCK POSITION” (B) “UNLOCK POSITION”
6. Top link
1. Adjust the angle of the implement to the desired
position by shortening or lengthening the top link.
2. The proper length of the top link varies according to
the type of implement being used.
(1) Top link (A) “Length of the screw”
NOTE :
• The length of the screw at both ends of the
top link must be the same always.
7. Stabilizer
The stabilizer is used to adjust the lower link width.
Rotate the turnbuckle to adjust the stabilizer length.
When adjusting, make sure both the stabilizers are
equal in overall length.
Turnbuckle locked position
After adjusting the stabilizer length, the turnbuckle must
remain in the locked position.
3-POINT HITCH AND DRAWBAR THE 3-POINT HITCH SETUP
78
M4N-071, M5N-091, M5N-111