Kubota L2180-1, Руководство оператора и каталог запасных частей

Страница: 19 / 40

ASSEMBLY
OM 0313QH-A
17
Figure 7
Mounting the Subframe under the Tractor
WARNING:
To avoid serious personal
injury: Park the tractor on level ground,
place the transmission in neutral, set the
parking brake, disengage the PTO, place all
control levers in neutral, shut off the
engine, remove the ignition key and allow
the rotating parts to stop BEFORE attaching
the subframe underneath the tractor.
Step 1: (Figure 7)
•
Lay the subframe on its parking stand (item
1).
•
Make sure the cylinder (item 2) is well
extended; the distance between the two
cylinder pins should be about 17". If not, sit
on the operator's seat, start engine, remove
parking stand and drive the tractor beside
the subframe. The tractor side where the
valve is must be next to the subframe
cylinder. Shut off the engine, and connect
the hoses' female quick couplers (Fig.6a,
item 5) to the male quick couplers on the
tractor's hydraulic valve (Fig.6a, items 8-9).
NOTE: To facilitate the installation of the
hydraulic connectors insallation, place the
hydraulic valve lever in floating position.
•
Sit on the tractor seat, start the engine and,
using the hydraulic valve lever, completely
extend the cylinder. Shut off the engine and
disconnect the hoses.
•
Sit on the operator's seat, start engine and
slowly drive the tractor over the subframe,
while aligning the tube of the front subframe
(item 3) and the tubes of the front bracket
(item 4). Also align the rear of the subframe
(item 6) with the tractor draw bar (item 5).
Shut off the engine.
•
Connect the quick couplers (Fig. 6a, item 5)
to the tractor's hydraulic ports (Fig. 6a, items
8-9), making sure to match colors of the
identification rings. The hoses are well
connected if the quick hitch lowers when the
hydraulic valve lever is pushed forward. If
operation is not as described, reverse the
hoses on tractor side, as well as the
identification rings to match colors.
•
Place the hoses (Fig.6a, item 1) in the hose
supports shown on figure 6c and install nylon
tie wraps to secure the hoses together.
•
Remove the draw bar (item 5) from the
tractor.