- 14 -
STORAGE
GENERAL CLEANING AND TIGHTENING
The Hedge Trimmer will provide maximum performance for many, many hours if it is maintained
properly. Good maintenance includes regular checking of all fasteners for correct tightness, and
cleaning of the entire machine. Pitch and gum deposits should be removed from the cutting blades
daily. Adjustment of the cutting blade tension should be checked regularly. Refer to page (9) for
instructions to adjust cutting blades.
For long-term storage of the Hedge Trimmer, empty the
fuel tank into a suitable fuel storage container. Pump the
primer bulb on the carburetor until all fuel is discharged
through the clear fuel return hose. Run the engine to
remove any fuel that may remain in the caburetor.
Perform all regular maintenance procedures and any
needed repairs. Remove the spark plug and squirt a very
small amount of oil into the cylinder. Pull the starter cord
once.
CAUTION
Oil may squirt out of the spark plug opening while pulling the starter cord. Protect your eyes and
keep your face away from the spark plug opening. Slowly pull the starter cord to bring the piston to
the top of the cylinder (TDC). Reinstall the spark plug. Liberally lubricated the blades with a light
(#10 wt.) oil. Store the Hedge Trimmer in a dry place away from excessive heat, sparks or open
flame.
OIL
LUBRICATION: GEARCASE AND BLADES
The gearcase has a felt wick located at the blade opening. As the Hedge Trimmer is used, the
grease within gearcase becomes very soft. The reciprocating blades constantly draw small
amounts of grease between the blade contact surfaces for additional lubrication. If the gearcase is
not lubricated at the recommended intervals, a gearcase failure will occur due to a lack of
lubrication.
Gearcase failures due to improper
maintenance are not covered by
KUBOTA warranty.
The gearcase and blades should be
lubricated after each 15 hours of
use. The amount of grease to be
applied is about 15g. But then, stop
applying when grease comes out
from the blade opening.
NOTE:
If the Hedge Trimmer is used under severe conditions such as high ambient temperatures
(above 25°C) or for extended continuous periods of operation, the gearcase and blades must be
lubricated every 2 hours.
Lubricate the gearcase at the grease fitting with a good quality #2 lithium-base grease. Lubricate
the blades using a light (#10 wt.) oil.
GREASE FITTING
FOR GEAR CASE
