Kubota KGZ770-MA1, Руководство оператора, Страница: 98 / 117

78 ADJUSTMENT
ENGLISH
ADJUSTMENT
MOTION CONTROL LEVER
To avoid personal injury:
A Park the machine on a firm and level surface.
A
If it is necessary to run the engine in an
enclosed area, use a gas tight exhaust pipe
extension to remove the fumes.
A Always try to work in a well-ventilated area.
A
Lift up and secure with jack stands or blocking
the rear of the machine, do not run the machine
while adjusting.
Remove rear wheels.
A
Do not adjust only one of the following
adjustments; exclude "MOTION CONTROL
LEVER ALIGNMENT".
They are interlinked.
A
If you feel you are unable to make the following
adjustments correctly and safely, contact your
local KUBOTA Dealer.
A
Right and left motion control levers can be adjusted
independently.
B
HST NEUTRAL
1. Lift-up and secure with jack stands or blocking the rear
of the machine frame.
2. Remove both rear wheels.
3. Start the engine, and run at maximum speed.
4. Place the motion control lever in the "NEUTRAL
LOCK" position.
5. If the rear axle is still turning, follow following steps to
adjust the neutral position.
6. Pull the latch lever and raise the operator's seat.
7. Remove the connector from the seat safety switch,
then temporarily install a jumper wire across the
terminals in the connector of the wire harness.
To avoid personal injury:
A
Do not operate the machine with a jumper wire.
A If you feel you are unable to make the following
adjustments correctly and safely, contact your
local KUBOTA Dealer.
8. Loosen the lock nut of the motion control rod.
Adjust the motion control rod until the rear axle rotation
stops.
9. Lengthen the rod by 1/2 turn and then tighten the lock
nut.
Place the motion control lever to the reverse position,
and move them to the forward slowly.
10.Place the lever in the "NEUTRAL LOCK" position, and
check that the rear axle does not rotate.
If the axle does not stopped rotating, adjust the "HST
NEUTRAL" again.
11.Adjust the other side "HST NEUTRAL" equally.
12.After adjustment, make sure to stop the engine
immediately.
(1) Motion control rod
(2) Lock nut