Kubota GL11000-CAN, Руководство оператора

Страница: 32 / 55

15 OPERATING THE GENERATOR
ENGLISH
COLD WEATHER STARTING
If the ambient temperature is below* -5 (23 ) and the
engine is very cold, start it in the following manner:
Take steps (1) through (5) in "STARTING THE ENGINE"
section.
A
If the ambient temperature is low, the preheating time
will take longer.
A
Shown below are the standard preheating times for
various temperatures. This operation, however, is not
required, when the engine is warmed up.
(If the engine fails to start after 10 seconds, turn off the
key for 30 seconds. Then repeat steps (6) and (7) above.)
A
Do not allow the starter motor to run continuously for
more than 10 seconds.
A
Be sure to warm up the engine, not only in winter, but
also in warmer seasons. An insufficiently warmed-up
engine can shorten its service life.
A When there is possibility of temperature drops below -
15
(5 ) detach the battery from the machine, and
keep it indoor in a safe area. Reinstalled the battery
before the next operation.
STOPPING THE ENGINE
6. Turn the starter switch (key) to the
"PREHEAT" position until the glow
plug indicator goes off.
Ambient temperature Preheating time
Above 10 (50 ) NO NEED
10 (50 ) to
-5 (23 )
Until glow lamp goes off
*Below -5 (23 )
Approx. 5 seconds after the
glow lamp goes off
Limit of continuous use 20 seconds
7. Turn the key to "START" position and
the engine should start.
1. Turn OFF all electrical device switches
for connected loads.
2. Turn OFF the circuit breakers.
3. Allow the engine to run with no load for
about 5 minutes before stopping the
engine completely.
4. Turn the main switch (key) to the "OFF"
position.
(1) Starter switch (Key) (A) "OFF"
(B) "ON"
(C) "PREHEAT"
(D) "START"