Kubota AP-SRT62, Руководство оператора

Страница: 14 / 36

10
Section 1: Assembly & Set-up
AP-SRT62, & AP-SRT76 Rotary Tillers 321-095MK
Table of Contents
7/31/17
Hydraulic Hose Hook-ups
!
DANGER
To prevent serious injury or death:
Hydraulic fluid under high pressure will penetrate skin. Wear
protective gloves and safety glasses or goggles when working
with hydraulic systems. Use a piece of cardboard or wood
rather than hands when searching for leaks. If hydraulic fluid
is injected into the skin or eyes, it must be treated by a doctor
familiar with this type of injury within a few hours or gangrene
may result. DO NOT DELAY.
Refer to Figure 1-6:
1. Route hydraulic hoses (#7, #8, & #9) along the most
convenient path to access your skid steer couplings
and sump.
2. Clean quick connect couplers of dirt and then connect
hoses (#7 & #8) to the skid steer couplers.
3. Make sure quick connect couplers have fully engaged.
If not, check couplers to see if they are same size and
type. Also, make sure all hydraulic pressure to the
couplers has been released.
4. Connect case drain line (#9) to sump as follows:
a. If case drain line is fitted with a coupler, connect
case drain line to the sump coupler.
b. If case drain line is not fitted with a coupler:
•
Wrap Teflon tape around 3/8" MNPT threads on
end of case drain line.
•
Screw any customer supplied fittings to case
drain line (#9) and to sump port until tight.
IMPORTANT: Collect and dispose all oil spills and
leaks in an environmentally safe manner.
IMPORTANT: Hose routing is the responsibility of
the owner/operator of the tiller. Pinched and/or
stretched hoses are not covered under the warranty.
IMPORTANT: Make sure all coupler fittings are
clean before connecting them together.
NOTE: If attaching to a Kubota compact track loader
or skid steer loader, route hydraulic hoses as shown
in Figure 1-7. Be sure to thread hoses through
spring hose loop (#2). Do not use Kubota’s SVL or
SSV Hose Stay.
Skid Steer Primary & Secondary
Ports
Refer to Figure 1-6:
Hydraulic flow and pressure from the skid steer primary
and secondary ports may vary. The primary port usually
delivers more power than the secondary port. This
means the bi-directional tines will have more power when
driven by the primary port. If operator prefers to mainly
turn tines in one direction, then couplings (#3 & #4)
should be attached to the hydraulic hoses so that the
primary port on the skid steer is driving the tines in that
direction. Consult your skid steer Operator’s Manual to
know which port is the primary port.
Hydraulic Hose & Couplings
Figure 1-6
Kubota Compact Tract Loader or skid Steer Loader
(Kubota SVL Shown)
Figure 1-7
37204
37204
2
Do Not Use
SVL or SSV
Hose Stay