Kubota AP-SBL2566, Руководство оператора

Страница: 15 / 44

11
Section 2: Equipment Hook-up & Unhook
10/07/16 AP-SBL2566, AP-SBL2574, & AP-SBL2584 Snow Blowers 370-478MK
Table of Contents
Snow Blower Hook-up
Refer to Figure 2-1:
!
DANGER
To prevent serious injury or death:
A crushing hazard exists while hooking-up and unhooking
attachment. Do not allow anyone to stand between attachment
and power machine while approaching or backing away from
the attachment. Do not operate lift and/or tilt controls while
someone is near the power machine and/or attachment.
!
WARNING
To prevent serious injury or death:
Check hitch fit-up frequently to make sure loader hitch is
properly positioned under the attachment’s top angle bar(s),
lock handles are locked down with lock pins fully seated in
their bottom notches, and attachment is in good operating
condition.
NOTE: The Snow Blowers are designed for skid
steers and tractors with front mounted loaders.
Section 2: Equipment Hook-up & Unhook
Hook-up to Snow Blower
Figure 2-1
35599
Bottom slots
Top Angle Bars
1
2
3
5
4
Refer to Figure 2-1:
1. Check for and remove debris in the hitch point areas
before hooking-up to Snow Blower.
2. Raise lock pins on loader hitch for hook-up.
3. Drive skid steer or tractor slowly to the Snow Blower
hitch making sure hitch plate on the skid steer/tractor
is parallel with the Snow Blower’s top angle bars.
4. Rotate top of skid steer/tractor tilt arms slightly
forward.
5. Position top of skid steer/tractor hitch plate under the
top angled bars and slowly raise loader hitch plate up
until hitch plate is seated under the top angle bars.
6. Rotate top of skid steer/tractor tilt arms back until
Snow Blower makes full contact with face of hitch
plate.
7. Push lock pins on the loader hitch down. Make sure
lock pins go through bottom slots in the Snow Blower
hitch and handles are fully locked down.
8. Set loader arms to float.
IMPORTANT: Set loader arms to float before
operating attachment. The skid shoes can have
increased wear if loader arms are rigid.