Kubota AP-SA20, Руководство оператора

Страница: 16 / 38

12
Section 1: Assembly & Set-up
AP-SA20 Hydraulic Post Hole Digger 317-215MK
Table of Contents
4/3/19
Auger Assembly & Disassembly
Figure 1-5
Auger Assembly
Refer to Figure 1-5:
1. Slide auger hub (#4) over gearbox output shaft (#1)
until mounting hole in gearbox output shaft and
13/16" holes in auger hub are in alignment.
2. Insert 3/4"-10 x 4 1/2" GR5 bolt (#2) and secure with
nylock nut (#3). Torque nylock nut tight.
3. Skip to “Hook-Up Post Hole Digger” on page 12.
Auger Assembly With Auger Extension
Refer to Figure 1-6:
1. Slide hub of auger extension (#7 or #8) over gearbox
output shaft (#1) until mounting hole in output shaft
and 13/16" holes in extension hub are in alignment.
2. Insert 3/4"-10 x 4 1/2" GR5 bolt (#2) and secure with
nylock nut (#4). Torque nylock nut tight.
3. Slide auger hub (#6) over auger extension (#7 or #8)
until 5/8" mounting hole “A” or “B” in extension (#7) or
hole “A”, “B”, “C” or “D” in extension (#8) align with
9/16" holes in auger hub (#6).
4. Insert 1/2"-13 x 4 1/4" GR5 bolt (#3) through 9/16"
holes in auger and auger extension hole and secure
with nylock nut (#5). Torque nylock nut tight.
5. Skip to “Hook-Up Post Hole Digger” on page 12.
Auger Disassembly
Refer to Figure 1-5:
1. Remove nylock nut (#3) and bolt (#2).
2. Remove auger (#4) from gearbox output shaft (#1) or
auger extension (#7) shown in Figure 1-6.
Auger Extension Disassembly
Refer to Figure 1-6:
1. Remove nylock nut (#4) and bolt (#2).
2. Remove extension (#7 or #8) from gearbox output
shaft (#1).
37274
Auger & Auger Extension Assembly & Disassembly
Figure 1-6
Hook-Up Post Hole Digger
DANGER
!
To avoid serious injury or death:
A crushing hazard exists while hooking-up and unhooking the
attachment. Do not allow anyone to stand between attachment
and power machine while approaching or backing away from
the attachment. Do not operate lift and/or tilt controls while
someone is near the power machine and/or attachment.
WARNING
!
To avoid serious injury or death:
Make sure skid/loader plate is properly attached to the Post
Hole Digger. The skid/loader plate must be secured under the
auger hitch top angle bar. Lock pins must extend fully through
bottom slots in the auger hitch in the locked down position. An
improperly attached hitch can allow equipment to fall and/or
be thrown towards bystanders and/or operator.
37275