PRINTED IN THE USA © KUBOTA TRACTOR CORPORATION 2022 Code: 77700
-
12811 (Rev. A)
■
ASSEMBLY PROCEDURE
15. Apply Velcro to the rear roof support above the snaps to
match the rear panel. Velcro should only be applied to clean
dry surfaces at room temperature. Apply Velcro down each
rear leg as well to match the rear panel. A strip of Velcro
should also be applied along the outside lip across the back
of the seat. Snap the rear panel into place and secure the
perimeter to the Velcro.
16. Per fig. 16, install the supplied ROPS decal to the inside
surface of the rear driver
’
s side ROPS tubing as shown.
Apply to a clean, dry surface at room temperature.
17. Apply grease to the door hinge pins.
18. Insert the hinge pins on the doors into the sleeves on
the vehicle. Slowly close the door. Adjust the striker pin
vertically in the slot if necessary. If contacting the top or
bottom of the striker pin, adjust the pin in the slot to avoid
excessive pin wear. The latch can also be moved forward
and backwards to catch on the center of the pin. Two
audible clicks should be heard when the latch is engaged
fully. If more adjustment is required, loosen the hinge pins
and adjust them as well. The hinge pins should be in
-
line
with each other when a straight edge is placed against the
back of them.
19. Connect the free end of the door stop cable to the door.
Leave it slightly loose so that the cable may rotate freely.
Fig. 16 (view of driver
’
s side rear ROPS tube)
apply
new
decal
here
Condition:
Explanation/Solution
Latch and pin does not line up
Move pin up or down.
(up and down)
Loosen hinges and lower or raise the front of the door.
Latch and pin does not line up
Move latch forwards or backwards. Loosen hinges and
(front to back) move door forwards or backwards.
Door does not seal
Carefully bend steel frame of door.
Troubleshooting the door
