Motorcycle controls
Magnetic Kill Switch
The magnetic kill switch is located on the left hand side of the handlebars. Always switch
the motorcycle into the OFF position when stopped or parked.
WARNING!
If the power is turned ON and the throttle is open, the motorcycle will accelerate
immediately. This is potentially very dangerous. The rider’s right hand should be used to
switch the power on, with no hands on the throttle.
Speed & torque control button
The speed & torque control button allows a responsible adult to set motorcycle
maximum power and torque. There are three distinct power & torque modes.
Go to page 15
to read detailed instructions concerning how to set the various power &
torque modes. Do not attempt to guess or assume these settings. Always check them
before allowing the rider back on the motorcycle.
Charging port
When it’s time to recharge the motorcycle, the battery charger connector attaches to
this port. Before attaching, ensure that the power is switched to the OFF position. Please
refer to the battery and charging section
(page 25)
of this manual for more information.
WARNING!
The power on the motorcycle must be switched OFF before attaching and plugging in
the charger.
Charge indicator
The LED battery charge indicator is located on the right side of the fork upper plate.
The LED illuminates
green
when the motorcycle is fully charged,
yellow
when the charge
reaches 65% and red when the battery charge reaches 30%. The
red
light will start
blinking when the battery charge is very low. From this point. the motorcycle will start
losing power and will be able to travel roughly 2 - 3 km (1 - 2 miles) before the motorcycle
shuts down completely.
Setting up your Kuberg
Challenger for riding
WARNING!
Improper set-up is dangerous! It is your responsibility to set the motorcycle to the
ability of the rider. Failure to do so, may result in injury or death, and/or damage to your
motorcycle.
NOTE:
A responsible adult must ensure that the KUBERG Challenger and its rider are prepared
for every ride. The motorcycle must be set to the abilities of the rider, and the rider and
the motorcycle must be supervised when ridden by a teenager. Novice riders can lose
concentration quickly, and be easily distracted. If the power is set too high, an accident
could occur.
RIDE SAFE!
Setting power & torque modes
Follow these steps to limit the maximum power and torque on your KUBERG Challenger:
1
Turn OFF your motorcycle.
2
Press and hold the map button. The map button is located on the right side of the
handlebars.
3
Turn ON your motorcycle.
4
The motorcycle will beep one, two or three times to indicate the desired power mode
1 beep - Beginner Mode (low-power)
2 beeps - Sport Mode (medium-power)
3 beeps - Race Mode (maximum-power)
14
CHALLENGER - OWNER‘S MANUAL
15
