TOP PANEL FUNCTIONS
1. PLUGIN BYPASS BUTTON : Turns on, off or bypass the rack extension device.
2. INPUT LEVEL : Controls the level of incoming signal. You may turn it to the maximum without worrying of overloading the amp.
3. INPUT METER : Shows the level of incoming signal. For optimal result, make sure the level reaches about 70-80% just before red
indicator starting to light up.
4. PRESET BROWSER
5. PRESET NAME DISPLAY
6. NOISE GATE ON/OFF : Enables or disables the noise gate utility.
7. NOISE GATE PARAMETERS :
• THRESHOLD : Sets the minimum level where the Noise Gate will do its job. If the input signal level is below threshold, the
noise gate will kick in by reducing the signal according to the Attack & Decay settings.
• ATTACK : This controls the time how quickly the gate will open when the signal is above the threshold level.
• DECAY : Determines how quick the gate closes once the signal has fallen below the threshold level.
8. FILTER ON/OFF : Turn the filters On or Off.
9. FILTER KNOB PARAMETER :
• HP (One Pole High pass) : Sets the center frequency of the high pass filter.
• LP (One Pole Low pass) : Sets the center frequency of the low pass filter.
10. OUTPUT LIMITER : Enable or Disable the output limiter function. This will compress the sound to prevent overloading.
11. OVERLOAD INDICATOR : Will light up red when the audio signal overloads. Turn the output volume down, or enable the
output limiter.
12. GLOBAL OUTPUT VOLUME : Adjusts the overall master volume from the plugin.
1
2
8
3
4
5
6
7
9
10
11
12
